Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10 Manual de usuario descargar pdf (Pagina 88)

Ethernet Interface

III-76 Slave Controller – IP Core for Altera FPGAs

9.2 MII Interface

The MII interface of the IP Core is optimized for low processing/forwarding delays by omitting a

transmit FIFO. To allow this, the IP Core has additional requirements to Ethernet PHYs, which are

easily accomplished by several PHY vendors.

Refer to “Section I – Technology” for Ethernet PHY requirements.

Additional information regarding the IP Core:

 The clock source of the PHYs is the same as for the FPGA (25 MHz quartz oscillator)

 The signal polarity of nMII_LINK is not configurable inside the IP Core, nMII_LINK is active low. If

necessary, the signal polarity must be swapped by user logic outside the IP Core.

 The IP Core can be configured to use the MII management interface for link detection and link

configuration.

 The IP Core supports arbitrary PHY addresses.

For details about the ESC MII Interface refer to Section I.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 140 141

Sin comentarios

Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10 Manual de usuario Pagina 88