Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10 Manual de usuario descargar pdf (Pagina 54)

IP Core Configuration

III-42 Slave Controller – IP Core for Altera FPGAs

5.2.5.1 No Interface and General Purpose I/O

If there is no interface selected no communication with the application is possible (except for general

purpose I/O).

Figure 14: Register Process Data Interface

Number of GPIOs

General purpose I/O signals can be added to any selected PDI. The number of GPIO bytes is

configurable to 0, 1, 2, 4, or 8 Bytes. Both general purpose outputs and general purpose inputs of the

selected width are available.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 140 141

® FPGAs 1
1 Overview 13
EtherCAT IP Core 14
Table 4: Release notes 18
Figure 3: Design flow 25
2 Features and Registers 28
(0x0108:0x0109) 29
Table 8: Legend 30
IP Core 31
V3.0.10 31
Table 10: Legend 33
3 IP Core Installation 38
Figure 5: License Setup 40
4 IP Core Usage 43
5 IP Core Configuration 44
Figure 8: Documentation 45
Figure 9: Product ID tab 46
09) is available if checked 51
6 Example Designs 61
7 FPGA Resource Consumption 69
8 IP Core Signals 71
CLK25_2NS 72
Table 20: SII EEPROM Signals 73
Table 21: LED Signals 73
PHY Management 75
Table 24: PHY Interface MII 76
Table 25: PHY Interface RMII 78
Table 28: Digital I/O PDI 82
Table 29: SPI PDI 83
Table 30: 8/16 Bit µC PDI 83
Table 31: 8 Bit µC PDI 83
Table 32: 16 Bit µC PDI 84
Table 33: Avalon PDI 84
Table 34: AXI3 PDI 85
9 Ethernet Interface 86
Ethernet PHY 87
RX_D[3:0] 91
10 PDI Description 99
Digital output pins 102
LATCH_IN 104
Figure 39: OUT_ENA timing 105
Table 46: SPI signals 106
Table 47: Address modes 107
SPI_DO (MISO) 112
SPI_DI (MOSI) 112
SPI_CLK* 112
SPI mode 1/3 SPI mode 0/2 113
PDI Description 114
16 bit µController, async 119
EtherCAT device 119
8 bit µController, async 120
(with preceding write access) 122
DATA0 DATA1 DATA2 DATA3 128
ADR+1 ADR+3ADR+2 128
Figure 57: AXI3 signals 129
Table 59: AXI3 signals 129
Figure 58: AXI Read Access 133
Figure 59: AXI Write Access 133
Output event time 134
Table 63: I²C EEPROM signals 135
Table 65: AC Characteristics 136
Table 66: Forwarding Delays 136
14 Synthesis Constraints 137
Synthesis Constraints 138
Synthesis Constraints 139
15 Appendix 141

Comentarios a estos manuales

Sin comentarios

Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10 Manual de usuario Pagina 54

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Beckhoff EtherCAT IP Core for Altera FPGAs v3.0.10