Beckhoff M1600 Manual de usuario descargar pdf (Pagina 9)

M1600 Parallel Input/Output Beckhoff II/O-System

Date : 8.8.94 Version : 2.0 Page 9 of 14

The following modul configuration is possible by setting jumpers 3 to 6 :

Fast Inputs M1600 (Interrupt Inputs)

Jumper 3 Fast input II3 :

If jumper connection betwenn port D0.3 and

XILINX II3 is established Fast input is activated

Jumper 4 Fast input II2 :

If jumper connection betwenn port D0.2 and

XILINX II3 is established Fast input is activated

Jumper 5 Fast input II1 :

If jumper connection betwenn port D0.1 and

XILINX II3 is established Fast input is activated

Jumper 6 Fast input II0 :

If jumper connection betwenn port D0.0 and

XILINX II3 is established Fast input is activated

Power Supply

There are the following connections for power supply :

(1) two pole plug connection for the controller (X10 Pin1+2)

(2) two pole plug connection for outputs (X20 Pin1+2)

( 16 outputs )

(3) two pole plug connection for inputs (X21 Pin1+2)

(16 inputs)

(4) two pole plug connection for ground (X22 Pin1+2)

(5) 2x two pole plug connection for 4 high current outputs (X30 Pin1+2 and Pin

7+8)

(6) 2x two pole plug connection for 4 high current outputs (X31 Pin1+2 and Pin

7+8)

The power supply of the 8 high current channels is potential seperated from the control locic

unit. Thus the +24VDC lines and the 0V lines are are connected seperately.

The +24 VDC supply is established by two two-pin connections.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Sin comentarios

Beckhoff M1600 Manual de usuario Pagina 9